EDgun Leshiy 2 plenum gauge adaptor

Plenum gauge adaptor for EDgun Leshiy 2 with both standard and Apex regulators. Allow you to attach pressure gauge with 1/8 BSP thread to the bleed hole on the rifle. Include the adaptor and the gauge sealing o-ring, the gauge on the picture is NOT included. Note that this adaptor doesn't seal against the bleeding hole's conical seal. You need to use Teflon thread sealing tape / plumber's tape to seal the adaptor against the rifle, the tape is NOT included.

To install:

1. Install the gauge to the adaptor, make sure that the included o-ring is properly seated and do not over tighten.

2. Apply 2-3 layers of Teflon thread sealing tape / plumber's tape to the small thread on the adaptor.

3. Take out the bleeding screw in front of the plenum

4. Screw in the adaptor to the bleeding hole. Make sure that you don't cross thread / overtighten.

Note that it's not recommended to install this adaptor permanently. It should only be used to verify / tune the regulator pressure.